Gold's Gym GGSY3058.0 manual Cable Assembly, See . Tighten the M10 Nylon Locknuts

18.Apply grease in the locations shown and attach the Left and Right Press Arms (15, 16) to the Base (1) with an M10 x 110mm Bolt (93), an 89.5mm Spacer (59), and an M10 Nylon Locknut (77). Do not over tighten the Nylon Locknut; the Press Arms must pivot easily.

See step 17. Tighten the M10 Nylon Locknuts (77).

Cable Assembly

19.See the CABLE DIAGRAMS on page 28 to identify the cables as you assemble them.

Identify the Butterfly Cable (50). Grease an

M8 x 22mm Shoulder Bolt (90). Attach the Cable to the Left Butterfly Bracket (28) with the Shoulder Bolt and an M8 Nylon Locknut (78). See the inset drawing. Make sure that the flat edge of the Cable is against the Left Butterfly Arm. Do not overtighten the Shoulder Bolt; the Cable must pivot easily.

20.Wrap the Butterfly Cable (50) over a “V”-pulley (47). Attach the “V”-pulley, a Long Cable Trap (57), an M10 Washer (80), and two Guards (54) to the Upright (2) with an M10 x 60mm Bolt (79) and an M10 Nylon Locknut (77).

18
16	15
77
	1
	59
	93
Grease
19
90	Grease
50	28
	78
Flat Edge
20
	77
2	54 50
	57
	54
	79
	80
	47

15