27.Route the Lat Cable (49) up through the Top Frame (4) and wrap the Cable over a Thin Pulley (24). Pull the M10 x 80mm Bolt (84) out of the Top Frame until it is flush with the first Thin Pulley from step 24. Do not remove the Bolt com- pletely from the Top Frame.
Hold the second Thin Pulley (24) inside the Top Frame (4) and attach it with the M10 x 80mm Bolt (84), a 19mm Spacer (67), an M10 Washer (80), and an M10 Nylon Locknut (77).
28.Wrap the Lat Cable (49) around a 90mm Pulley (48) and route the Cable down through the Top Frame (4). Attach the Pulley to the Top Frame with an M10 x 80mm Bolt (84), two M10 Washers (80), two 19mm Spacers (67), and an M10 Nylon Locknut (77).
29.Set an M12 Large Washer (98) on top of the Weight Selector (20). Thread the M12 Nut (112) all the way onto the Lat Cable (49).
Thread the Lat Cable (49) into the Weight Selector (20) two turns. Tighten the M12 Nut (112) against the M12 Large Washer (98).
27 | 24 |
|
|
|
|
| |
| 49 |
| 80 |
| 84 |
| |
|
|
| |
| 113 |
|
|
| 4 | 67 | |
|
|
| 77 |
28 | 84 |
| 67 48 |
| 80 | ||
|
| ||
|
|
| 67 |
|
|
| 80 |
| 49 |
| 77 |
| 4 |
|
|
29 |
|
|
|
|
|
| 49 |
|
|
| 112 |
|
|
| 98 |
|
|
| 20 |
18
