Gold's Gym GGSY3058.0 manual Do not tighten the Nylon Locknuts yet

1.

Frame Assembly

Before beginning assembly, make sure that you understand the information in the box on page 8. See the PART IDENTIFICATION CHARTS on pages 5–7 for help identifying small parts.

1

Insert four M8 x 75mm Carriage Bolts (83) up into the Base (1). Note: It may be helpful to place a piece of tape over each bolt head to hold it in place.

2.Insert the two Weight Guides (18) into the Stabilizer (3). Make sure that the indicated holes in the Weight Guides are nearer the floor.

Attach the Stabilizer (3) and the Weight Guides (18) to the Base (1) with two M10 x 85mm Bolts (81), two M10 Washers (80), two 21mm Steel Spacers (108), and two M10 Nylon Locknuts (77).

Do not tighten the Nylon Locknuts yet.

Next, attach the Weight Guides (18) to the Stabilizer (3) with two M10 x 20mm Button Screws (96). Then, attach the Stabilizer to the Base (1) with an M8 x 75mm Carriage Bolt (83) and an M8 Nylon Locknut (78). Do not tighten the Nylon Locknut yet.

Attach the Upright (2) to the Base (1) with the two indicated M8 x 75mm Carriage Bolts (83) and two M8 Nylon Locknuts (78). Do not tighten the

Nylon Locknuts yet.

3.Attach the Front Leg (10) to the Base (1) with the two M8 x 75mm Carriage Bolts (83) and two M8 Nylon Locknuts (78). Do not tighten the Nylon

Locknuts yet.

Attach the Leg Lever Bumper (75) to the Front Leg (10) with an M4 x 16mm Self-tapping Screw (110) and an M4 Washer (104). Make sure that the end of the Leg Lever Bumper is pointing up.

1	83
83
2
18

Holes

2	78	80	81
	77
	78		80
78		83	3
	1	108
	83	96
3
	75	10
	104
	110	78
	78
		83
		1

9