Getting Started

d.set AllControl to

PRIME/CLEAN GUN & HOSE.

Install Tip and Guard

ti9171a

11.Continue to trigger into waste pail until you see only paint coming out of gun.

12.Release trigger. Engage trigger lock.

ti8923a

13.Transfer drain tube to paint pail and clip prime tube to suction tube.

• Motor stopping indicates pump and hose are primed with paint.

If motor continues to run the sprayer is not properly primed. To reprime repeat step 6.

14.If spraying, install tip and guard on gun, page 13 and see Spraying Techniques, page 14.

If rolling, roller setup and Rolling Techniques, begin on page 18.

1. Engage trigger lock.

ti8923a

2.Verify tip and guard parts are assembled in order as shown below.

retaining nut

black rubber gasket and

 

 

metal seat

 

guard

ti8911a

 

tip

 

 

 

 

Use tip to align seat

Tip must be pushed

in guard.

all the way into guard

TIA

ti9574a

3.Screw tip and guard assem- bly on gun. Tighten retaining nut.

ti9255a

312079A

13

Page 13
Image 13
Graco 261800 specifications Install Tip and Guard