Pull and hold gun trigger Turn AllControl to

Shutdown & Cleaning - After Direct Immersion Method Applications

Step 12 is for returning paint in hose back to paint pail. One 25-ft (7.5 m) hose holds

approximately 1-pint (0.5-liter) of paint.

12.To preserve paint in hose:

a.Point gun into paint pail.

b.Unlock gun trigger lock.

ti8922a

c.Pull and hold gun trigger.

PRIME/CLEAN GUN & HOSE.

ti9171a

Continue to hold gun trigger until you see paint diluted with flushing fluid starting to come out of gun.

13.While continuing to trigger gun, quickly move gun to redirect spray into

waste pail. Continue triggering gun into waste pail until flushing fluid

dispensed from gun isti9745a relatively clear.

14.Stop triggering gun. Engage trigger lock.

ti8923a

15. Turn AllControl to OFF.

17.Clip drain tube to hopper.

18.Use a soft brush to clean paint and debris off strainer. Install strainer in hopper.

19.Clean gun fluid filter (d) with water or flushing solvent and a brush every time you flush the system. Replace gun filter if damaged.

ti9257a

20.Clean tip and guard with water or flushing solvent. A soft brush can be used to loosen and remove dried on material if needed.

ti9671a

21.Wipe paint off outside of gun using a soft cloth moistened with water or flushing solvent.

22.Use a soft cloth to wipe off hopper, cover, and hose.

312079A