Shutdown & Cleaning - After Direct Immersion Method Applications

Shutdown & Cleaning - After Direct Immersion Method Applications

Pail Flushing

• For short term shutdown periods (over- night to one week) refer to Short Term Storage, page 29.

For flushing after spraying oil-based coat- ings, use compatible oil-based flushing fluid or mineral spirits.

For flushing after spraying water-based coatings, use water.

If you are using water-based materials, you have the option of following the cleanup procedure described below, or for faster cleanup, Power Flush, starting on page 26.

5.Place waste and paint pail side by side.

ti9726a

6.Submerge suction tube in water or flushing solvent.

ti9827a

7.Place prime tube in waste pail.

1.Relieve pressure, page 7.

ti9825a

2.If you used a spray gun, remove tip and guard assembly from gun and place in flushing fluid.

If you used a roller, leave roller assembly attached to gun.

3.Lift suction tube and prime tube from paint pail. Let them drain into paint for a while.

4. Separate prime tube (smaller) from suction tube (larger).

TIA

8.Set AllControl to

PRIME/CLEAN PUMP.

ti9169a

9.Flush until approximately 1/3 of the flushing fluid is emptied from the pail.

10.Turn AllControl to OFF.

11.

a. If you used a spray

 

gun only, continue

ti9168a

Pail Flushing, Step 12.

 

b.If you used a roller follow Cleaning Roller instructions beginning on page 28.

24

312079A

Page 24
Image 24
Graco 261800 specifications Pail Flushing