Allow DHCP Option 42 Override NTP Server

SSL Certificate

SSL Private Key

SSL Private Key Password

System Ring Tone

Call Progresses Tones:

Dial Tone

Message Waiting

Ring Back Tone

Call-Waiting Tone

Busy Tone

Reorder Tone

Disable Call-Waiting

Disable Call-Waiting Tone

Disable Direct IP Calls

Use Quick IP-Call mode

Disable Conference

Enable MPK sending DTMF

Enable FLASH key as CONF

Defines whether DHCP Option 42 should override NTP server or not. When enabled, DHCP Option 42 will override the NTP server if it's set up on the LAN. The default setting is "Yes".

SSL Certificate used for SIP Transport in TLS/TCP.

SSL Private key used for SIP Transport in TLS/TCP.

SSL Private key password used for SIP Transport in TLS/TCP.

System ring tone. Default is North American standard. Users could adjust system ring tone frequencies and cadences based on local telecom standard.

Using these settings, users can configure ring or tone frequencies based on parameters from local telecom. By default, they are set to North American standard.

Frequencies should be configured with known values to avoid uncomfortable high pitch sounds.

Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]]; (Frequencies are in Hz and cadence on and off are in 10ms)

ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of silence. In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up to three cadences are supported.

Disables the call waiting feature. The default setting is "No".

Disables the call waiting tone when call waiting is on. The default setting is "No".

Disables Direct IP Call. The default setting is "No".

When set to "Yes", users can dial an IP address under the same LAN/VPN segment by entering the last octet in the IP address. To dial quick IP call, offhook the phone and dial #XXX (X is 0-9 and XXX <=255), phone will make direct IP call to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet mask. #XX or #X are also valid so leading 0 is not required (but OK). No SIP server is required to make quick IP call. The default setting is "No".

Disables the Conference function. The default setting is "No".

Enables Multi Purpose Key to send DTMF during the call. The default setting is "No".

If set to "Yes", FLASH key can be used to establish 3-way conference.

FIRMWARE VERSION 1.0.4.23

GXP1100/GXP1105 USER MANUAL

Page 38 of 46

Page 38
Image 38
Grandstream Networks GXP1105, GXP1100 user manual Firmware Version