Grizzly owner manual Foot pedal and caster installed G0453/G0454 Mfg. Since 3/08

12.Using the short end of a clean hex wrench, dip it inside the fill hole and remove it.

—If the end of the hex wrench is coated with oil, then the gearbox oil level is okay. Replace the fill plug and skip to the next section.

—If the end of the hex wrench is not coated with oil, then you need to add more oil. Refer to Page 32 for instructions on how to do this.

NOTICE

Replace the gearbox oil after the first 20 hours of operation. This is a normal break- in procedure.

13.Remove the pin and hex bolt that are already mounted in the foot pedal bracket.

14.Align the caster assembly with the mounting holes in the foot pedal bracket.

15.Insert the hex bolt into the hole in the back side of the caster assembly, and tighten the bolt just enough for it to be snug without ham- pering the pivot action of the caster.

16. Install the foot pedal to the caster and secure together by inserting the pin between the two parts.

17.Lock the caster and pedal in place with the E-clip and washers, as shown in Figure 13.

Pin, E-Clip	Hex Bolt & Nut
& Washers
	Bracket
Foot Pedal	Caster

Figure 13. Foot pedal and caster installed.

-20- G0453/G0454 (Mfg. Since 3/08)