4.Push the OFF button in, then twist it clock- wise so it pops out. When the OFF button pops out, the switch is reset and ready for operation (see Figure 14).
Figure 14. Resetting the switch.
5.Verify that the machine is operating correctly by pushing the ON button.
—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.
—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.
6.Press the OFF button to stop the machine.
7.WITHOUT resetting the switch, press the ON button. The machine should not start.
—If the machine does not start, the OFF but- ton safety feature is working correctly. The Test Run is complete.
—If the machine does start (with the OFF button pushed in), immediately disconnect power to the machine. The OFF button safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.
Re-Tension V-Belts
The final step of the setup process must be done after approximately 16 hours of operation. During this period, the
Recommended
Adjustments
For your convenience, the adjustments listed below have been performed at the factory.
However, because of the many variables involved with shipping, we recommend that you at least verify the following adjustments to ensure the best possible results from your new machine.
Factory adjustments that should be verified:
•Table height chain tension (Page 39).
•Chip breaker height (Page 40).
•Pressure bar height (Page 40).
•Infeed/outfeed roller height (Page 40).
•Roller spring tension (Page 43).
•Chip deflector positioning (Page 43).
G0453/G0454 (Mfg. Since 3/08)
