Dust Collection |
| Test Run |
|
|
|
|
|
|
DO NOT operate the Model G0453/G0454 without an adequate dust collection system. This planer creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at Dust Port
•G0453..........................................400 CFM
•G0454..........................................625 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
Check Gearbox Oil
It is critical that you make sure there is oil in the gearbox before proceeding with the test run. Refer to the Lubrication instructions for the gearbox on Page 32 for more details on which type of oil to use, how much to use, and where to put it.
GEARBOXES MUST
BE FILLED WITH OIL!
NO OIL SHIPPED WITH
MACHINE!
Requires
or Equivalent
Gear Oil.
Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation. The test run consists of verifying the following: 1) The motor powers up and runs correctly and 2) the stop button safety feature works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 33.
If you cannot find a remedy, contact our Tech Support at (570)
Before starting the planer, make sure you have performed the preceding assembly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety features on this machine. Failure to follow this warning could result in serious personal injury or even death!
To test run the machine:
1.Make sure you understand the safety instruc- tions at the beginning of the manual and that the machine is set up properly.
2.Make sure all tools and objects used during set up are cleared away from the machine.
3.Make sure the gearbox has the correct amount of oil (refer to Gearbox Oil on Page 32 for detailed instructions).
G0453/G0454 (Mfg. Since 3/08) |
