4.Place the bushing on the handwheel shaft.
5.Insert the key into the shaft keyway.
6.Screw the handle into the handwheel.
7.Place the handwheel on the shaft and secure it with the
Figure 9. Installing the table height handwheel.
8.Model G0453: Attach the dust hood to the top of the planer with the M6-1 x 10 hex bolts, 6mm flat washers, and M6-1 hex nuts as shown in Figure 10, then attach the bottom of the dust hood to the planer with the M8-1.25 x 20 cap screws.
Note: You will need to reach into the dust hood to get access for fastening the nuts.
Figure 10. Dust hood attached.
G0453/G0454 (Mfg. Since 3/08)
Model G0454: Attach the dust hood with the provided M6-1 x 12 flange bolts.
9.Remove the two cap screws already installed on the left-hand side of the head casting.
10.Attach the switch bracket with the two cap screws, as shown in Figure 11.
Figure 11. Attaching magnetic switch.
NOTICE
Before starting your machine, you must make sure the gearbox has the proper amount of oil to avoid machine damage.
11.Remove the gearbox fill plug (see Figure 12).
Fill Plug
