Setting/Replacing
Knives
Planer knives are extremely sharp and can quickly cause a serious injury to your hands or fingers. Always wear heavy leather gloves when handling these knives to reduce the risk of cutting injuries.
Setting the height of the knives correctly is cru- cial to the proper operation of your planer and is very important in keeping the knives sharp. If one knife protrudes higher than the others, it will do the majority of the work, dull much faster, and produce poor cutting results.
The knife gauge that is included with the Model G0453/G0454 is designed to set the knives 0.059" higher than the cutterhead surface.
Note: If you need to replace or sharpen a knife, you can remove the knife from the cutterhead dur- ing Step 4 of the following procedure. Thoroughly clean out any debris from the knife slots before replacing the knives.
Replacement knives are available through Grizzly (refer to Page 28 for options).
Tools Needed | Qty |
Hex Wrench 2.5mm (G0453) | 1 |
Wrench 10mm (G0453) | 1 |
Hex Wrench 3mm (G0454) | 1 |
Wrench 12mm (G0454) | 1 |
Knife Gauge | 1 |
To adjust the height of the knives: |
|
1.DISCONNECT PLANER FROM POWER!
2.Remove the dust hood and the top cover to expose the cutterhead.
3.Remove the belt cover, then rotate the cutterhead pulley to give you good access to one of the knives.
Note for G0454 Only: The cutterhead for the Model G0454 ships with both springs and jack screws to adjust the knife height (see Figure
Loosen
Tighten
Knife
Jack Screw
(G0454 Only)
Gib
Spring
Gib Bolt
Figure 34. Cutterhead components (G0454
cutterhead shown).
4.If you have not already done so, loosen the cutterhead gib bolts until the knife is completely loose, then position the knife gauge over the knife so that the knife edge is directly under the center pad, as shown in
Figure 35.
Center | Knife | |
Pad | ||
Gauge | ||
|
