Grizzly G0453, G0454 owner manual To adjust the bed rollers, Disconnect Planer from Power

NOTICE

Bed rollers that are not adjusted to the cor- rect height or out of alignment with each other can cause poor finishes, inconsistent planing thickness, and other undesirable results.

Tools Needed	Qty
Hex Wrench 3mm	1
Wrench 14mm	1
Rotacator	1
To adjust the bed rollers:

1.DISCONNECT PLANER FROM POWER!

2.Lower the table all the way to give yourself room to work.

3.Loosen the set screws above each of the four roller adjustment hex bolts (see Figure 19).

Set Screws

Adjustment

Hex Bolts

Figure 19. Bed roller height controls.

G0453/G0454 (Mfg. Since 3/08)

4.Rotate the eccentric adjustment hex bolts to raise or lower the bed rollers until they are the desired height above the table surface.

5.Verify that both sides of each roller are at the same height, then re-tighten the four set screws to secure the setting.

6.Re-check the roller heights to make sure they did not change when you secured them.

—If the roller heights are not correct, repeat this procedure until they are.

-27-