5.Place the straightedge on the outfeed table so it hangs over the cutterhead, and lower the outfeed table until the straightedge is 0.062" (1⁄16") above the cutterhead body, as determined by using the feeler gauges (see Figure 53).
��������������
������������
�������������
������������
Figure 53. Using feeler gauges to set outfeed
table height.
6.Tighten the outfeed table lock located at the front of the machine, and tighten the positive stop bolts and jam nuts located at the back of the machine (see Figure 47).
7.Set the knife heights (Page 34) to the new outfeed table height.
Setting Infeed Table
The infeed table on the Model G0609 has positive stop bolts that, when properly set up, allow the operator to quickly adjust the infeed table between finish/final cuts and shaping/heavy cuts.
We recommend setting the minimum depth of cut to 1⁄32" and the maximum depth of cut to 1⁄8" for most operations. DO NOT exceed 1⁄8" cut per pass on this machine or kickback and serious injury may occur!
Each positive stop bolt (Figure 54) controls the top or bottom range of the table movement. The jam nuts lock the positive stop bolts in position so they won't move during operation.
Jam Nut |
| Jam Nut |
Bottom |
| Top Height |
Height |
|
|
