4.Raise the guide post and place a machinist’s square on the table next to the side of the blade as illustrated in Figure 16. Adjust the table square with the blade using the table tilt handwheel, then secure with the table tilt lock lever.
Figure 16. Squaring table to blade.
5.Adjust the positive stop bolt so it just touches the table and secure it by tightening the jam nut against the bandsaw.
6.Check the adjustment for accuracy once you have tightened the jam nut.
7.Loosen the screw on the table tilt scale point- er, but do not remove it.
8.Align the tip of the pointer with the 0˚ mark on the table tilt scale, then tighten the screw to secure the setting.
Dust Collection
DO NOT operate the Model G0636X without an adequate dust collection system. This saw creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at each Dust Port: 400
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust col- lector, (2) hose type and length between the dust collector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to calculate these variables is beyond the scope of this manual. Consult an expert or pur- chase a good dust collection
To connect a dust collection hose:
1.Fit a 4" dust hose over each dust port, as shown in Figure 17, and secure in place with a hose clamp.
2.Tug each hose to make sure it does not come off. Note: A tight fit is necessary for proper performance.
