Grizzly G0636X owner manual Coplanarity Gauge

9.Figure 69 shows the positions of the wheels when coplanar. When your wheels are copla- nar, reinstall the table, table insert, and pin, readjust the guide blocks and rear support bearings, and close the wheel covers.

10.Finally, check table and fence alignment (see Pages 25 & 26).

Note: The blade may track slightly off-center when the wheels are coplanar. This is natural because the blade will be balanced on the crown of the tire, rather than just in the center of the tire. This will be more noticeable with larger blades.

Coplanar	Parallel, Not	Not Parallel	Adjust
	Coplanar	Not Coplanar	Tracking Knob

Coplanarity Gauge

Coplanarity

Gauge

Contacts Top

And Bottom of

Both Wheels

Shim Upper

Wheel Out

Adjust

Lower

Hub

Figure 69. Coplanarity diagram.

-48- G0636X 17" Ultimate Bandsaw