Aligning Fence
To ensure cutting accuracy when the fence is first installed, the fence should be aligned with the
miter slot.
To align the fence parallel with the miter slot:
1.DISCONNECT BANDSAW FROM POWER!
2.Make sure the miter slot is aligned with the bandsaw blade (see Page 25).
3.If the fence is mounted on the
4.Loosen the two cap screws that secure the rail to the table (Figure 33).
Cap Screws
Figure 33. Cap screws securing rail to table.
5.Adjust the fence face parallel with the edge of the miter slot, as shown in Figure 34.
Figure 34. Example of fence square with miter
slot.
6.Tighten the two cap screws that secure the rail to the table, being careful not to move the fence.
NOTICE
Adjusting the fence parallel to the miter slot does not guarantee straight cuts. The miter slot may need to be adjusted parallel to the side of the blade. Refer to the "Aligning Table" instructions on Page 25.
