Grizzly owner manual Belts, Belt tension Model G0705 Mfg. since 09/09

5.Using the longitudinal handwheel, move the table as far to one side as possible.

6.Use mineral spirits and a brush to clean as much of the oil and debris as possible off of the longitudinal leadscrew shown in Figure 56. Allow the leadscrew to dry.

Figure 56. Longitudinal leadscrew location.

7.Apply oil to the exposed leadscrew threads, then move the table through its full range of longitudinal motion several times to disperse the oil along the full length of the leadscrew.

-40-

V-Belts

Inspect regularly for tension and wear. Refer to Figure 57 for proper belt tension. Belt deflec- tion should be approximately 1⁄4" under moderate pressure. Replace when necessary with a size B-42 belt for the spindle pulley to the idler pulley and a size B-33 belt from the idler pulley to the motor pulley. Check pulleys to ensure that they are properly aligned.

To replace the V-belts, refer to Speed Changes on Page 29 to loosen the belts. Remove them from the pulleys, then install new V-belts.

Pulley

1⁄4" Deflection

Pulley

Figure 57. Belt tension.

Model G0705 (Mfg. since 09/09)