Grizzly G9953ZXF, G4815 instruction manual Depth-Of-Cut Scale

Depth-Of-Cut Scale

The depth-of-cut scale indicates the amount of material that will be removed with each pass over the jointer.

To set the depth-of-cut scale:

1.Unplug the machine from the power source!

2.Open the access door on the back of the machine, just below the fence adjustments.

3.Place a straightedge on the outfeed table so it hangs over the infeed table.

4.Turn the cutterhead pulley so the knives or carbide cutters are NOT directly beneath the straightedge.

5.Loosen the infeed table lock knob.

6.Turn the infeed table handwheel to raise or lower the outfeed table until it just touches the straightedge as shown in Figure 44.

Infeed table just touch-

ing the straightedge

Figure 44. Properly adjusting the infeed table before setting the depth-of-cut scale.

7.Tighten the infeed table lock knob.

8.Loosen the depth-of-cut pointer screw and adjust the depth pointer to the “0” position as shown in Figure 45.

Figure 45. Depth-of-cut pointer

adjusted to “0” position.

9.Tighten the depth-of-cut pointer screw.

Ultimate Series Jointers -37-