Infeed Table To
Outfeed Table
Alignment
NOTICE
Review the "Knife To Outfeed Table Alignment" and the "Carbide Cutter To Outfeed Table Alignment"
The surface of the infeed table must be perfectly level with the surface of the outfeed table.
To verify the factory setting:
1.Position the edge of a steel straightedge on the outfeed table so that it extends over the cutterhead and onto the infeed table (Figure 19).
Infeed Table Just Touching
The Straightedge
Figure 19. Verifying that the infeed table is
even with the outfeed table.
2.Loosen the infeed table height lock knob (page 10, #9).
3.Turn the infeed table height handwheel (page 10, #8) to raise the infeed table until it just touches the straightedge WITHOUT lifting it off the outfeed table.
4.Tighten the infeed table lock knob.
5.Check the alignment of the tables with the straightedge at the various points shown in Figure 20. Again, the straightedge should sit perfectly flat across both the infeed and out- feed tables with no gaps.
Straightedge |
Figure 20. Positions for straightedge.
6.If all the table adjustments are set correctly, the depth-of-cut scale should read "0" as shown in Figure 21. If these conditions are not present, refer to Section 8: Service Adjustments.
Figure 21. Depth of cut scale.
Ultimate Series Jointers |
