Grizzly w1702 instruction manual Threading drawbar nut onto drawbar

Drawbar Nut

Taper Side Up

Figure 20. Threading drawbar nut onto drawbar.

Figure 21. Tightening the drawbar nut onto the

end of the drawbar.

6.Thread the tapered drawbar nut onto the end of the drawbar under the table, and make sure that the taper side of the nut is facing upward as shown in Figure 20.

7.Tighten your selected spindle in the shaper as outlined below:

•For shaper spindles: Place the spindle wrench on the top end of the spindle. Using a 15mm open-end wrench, tighten the drawbar nut while holding the spindle wrench secure as shown in Figure 21. DO NOT over-tighten the drawbar nut.

•For router bit spindles: Hold the router bit spindle flat on the shank—NOT the collet nut. Using a 15mm open-end wrench, tighten the drawbar nut while holding the router bit spindle in position with a wrench. DO NOT over-tighten the drawbar nut.

ONLY operate your shaper in the COUNTER- CLOCKWISE direction as looking downward at the spindle when when you use a router bit adapter. Router bits are designed to cut in the counter-clockwise direction only. DO NOT operate the shaper in the clockwise direction to make any sort of router-bit back cut. If this caution is ignored, the workpiece can kick back, or the collet can loosen and throw the cutter causing severe injury or death!

ASSEMBLY

-15-