Grizzly w1702 specification

Figure 36. Spindle washer placement.

Figure 37. Collar or spacer placement.

UNPLUG the power cord before you do any assembly, adjustments, or maintenance tasks! Otherwise, serious personal injury to you or others may occur!

To install a cutter, do these steps:

1.UNPLUG THE SHAPER!

2.Place the bushing (if needed) onto the spindle for cutter support as shown in Figure 34.

3.Slide the cutter onto the spindle, making sure the rotation is correct for the specific application as shown in Figure 35.

4.Place the spindle washer onto the spindle as shown in Figure 36.

5.Install spacers or collars if necessary for the specific application, followed by the nut and locknut as shown in Figures 37 and 38.

OPERATIONS

Figure 38. Spindle nut placement.

-25-

Image 27

Grizzly w1702 instruction manual Place the spindle washer onto the spindle as shown in Figure

Contents

HP Shaper Page Contents Woodstock Service and Support IntroductionAbout Your New Shaper Specifications Warranty and Returns Standard Safety Instructions Safety Safety Additional Safety Instructions for Shapers Use a Shop FOX Featherboard as Avoiding Potential Injuries Grounding Electrical220V Operation Extension Cords Assembly UnpackingInventory Beginning Initial Cleaning Shop Preparation Dust Collection Safety Guard Fence FacingAuxiliary Guard Handwheel To install the hold-downs, do these stepsTo install the crank handle, do these steps Hold-Downs Unplug the Shaper Spindle Threading drawbar nut onto drawbar Adjustments To adjust the fence, do these stepsFence Positioning Fence Alignment Table Inserts To adjust the table inserts, do these steps To align the pulleys, do these steps Pulley Alignment Spindle RPM Choose Spindle RPMTo change the spindle RPM, do these steps To check the spindle slide-to-gib clearance, do these steps Spindle Slide and Gib Start Up Operations Cutter Direction Forward and reverse switch Choose Spindle and Cutter RPM Cutter InstallationChoose Cutter Profile and Cutter Choose Cutter Height and Spindle Size Place the spindle washer onto the spindle as shown in Figure To set the spindle height, do these steps Setting Spindle Height Straight Shaping Operations Rub Collars There are three set up positions for rub collars Starting pin operation Guard not shown for clarity Freehand Shaping To make a template, do these steps Pattern Shaping Lubrication MaintenanceGeneral Table and Base Troubleshooting Closure Model W1702 220V Wiring Diagram Parts Stand Parts Handle Parts XPR15M Parts XPW02 Lock Washer 3⁄8 Parts Miter Gauge Body HOLD-DOWN BAR Shaper Accessories Shaper Accessories Your Notes Your Notes Warranty Card BOX BELLINGHAM, WA