Grizzly w1702 instruction manual Table Inserts, To adjust the table inserts, do these steps

Table Inserts

The table inserts are necessary for the safe operation of the shaper. Two inserts are provided allowing for three different opening sizes to be achieved. Use the smallest-size opening for a cutter to reduce wood chips falling into the machine, which could cause flying debris. Using the smallest-size opening also covers any unused portion of the bit below the surface of the table, thus reducing the chance of operator injury.

To adjust the table inserts, do these steps:

1.UNPLUG THE SHAPER!

2.Using a screwdriver, remove the three Phillips® head screws holding the cast iron insert in the table. See Figure 25.

3.Using a straightedge as a guide, turn the barrel-head screws either way until the insert is flush with the top of the table as shown in Figures 24 and 25.

4.Once the entire insert is flush with the table top, reinsert the three Phillips® head screws and tighten.

ADJUSTMENTS

Figure 24. Barrel-head screw.

Figure 25. Use a straightedge to make sure

insert is flush with table.

-18-