Guardian Technologies DFT 150/175 5.3Remote Setup, 5.4DVST Commands, Help, Quit, Reset, View

Setup DVST Installation Guide

5.3Remote Setup

Remote DVST units can also be set up in the same manner as a local DVST. The same procedure should be followed when the DVST is on line to a remote unit. When the SETUP key is pressed the screen will go blank and the command prompt REM> will appear on screen.

Proceed as for the local system.

Note: A PC cannot initiate remote set up with the “+++” command.

5.4DVST Commands

Most commands are typed in direct and terminated by pressing the <ENTER> key on a PC.

HELP Lists all commands available.

Note: Paragraphs 4.6 onwards detail the command information listed by the help option and have been grouped together in the logical order that should be used when setting up a DVST system.

QUIT Exits the SETUP mode.

This returns the DVST to normal operation. If a MODEM is connected and the DVST is set to MODEM=ON the initialisation strings will be sent to the MODEM.

RESET Resets DVST to factory defaults

This command is used to completely reset the DVST system. (All values are reset to their default values.)

Note: These values are stored in an integrated circuit called an EEPROM. This is not dependent on a battery backup and will retain its settings indefinitely without a power supply.

VIEW Display current DVST settings

This will display all the current DVST settings.

Page 10 Dedicated Micros Ltd