Guardian Technologies DFT 150/175 TELn=, Set telephone entry n to, default, blank, default, ISDN0

DVST Installation Guide Calls

10.3Telephone Number Entries / Connection Commands

TELn=	Set telephone entry n to ...
	(default, blank)
	Twenty telephone numbers can be stored in memory.
	Format: TEL2=01044617944965
	If the MODEM or ISDN Terminal Adapter is to work in the DIRECT
	mode, the entry can be left blank.
	Telephone number 0 is the default number dialled when alarms are
	used to initiate a call to another system. The fall back number if this is
	engaged is always stored in telephone number 1.

Where a number is used with dual ISDN dialling it is automatically linked with that number plus 10. Therefore Tel number 4 & 14 would be dialled if dual ISDN was selected for that telephone number.

TELn Set telephone entry n as current

This selects the number that will be dialled initially if the up/down keys are not used to select another.

Format: TEL2

TYPEn= Set telephone entry type to dial via ISDN0, ISDN1, ISDNx2 (dual), or MODEM

(default, ISDN0)

Each of the telephone numbers can be linked to either a PSTN MODEM or an ISDN terminal adapter.

This command determines which of the external ports (MODEM, ISDN Port0, or ISDN Port1) will be used when a particular telephone number is selected.

Format:

TYPE0=ISDN0

TYPE1=ISDN1

TYPE2=ISDN2

TYPE3=MODEM

TYPE4=MODEM2

Example: TYPE5=2

Sets Telephone entry 5 to ISDN2

Dedicated Micros Ltd Page 45