Powering Off GyroRemote

After 3 minutes of non-use, GyroRemote enters a Sleep Mode that conserves battery life. In Sleep Mode the unit only uses battery power when a button is pushed. It is not necessary to power down the unit when it is idle unless the unit will be traveling and may encounter inadvertent button presses.

1.To power down GyroRemote, simultaneously press and release the CHANNEL button and TEACH button on the side of unit. GyroRemote will immediately enter deep sleep mode and will be unresponsive to button clicks. The unit will confirm it is powering off by flashing its LED three times.

2.Repeat this sequence to power the unit back on. The unit will confirm it is powering on by flashing its LED for 1 second.

Note: It may be necessary to power off the unit when traveling on commercial airlines due to FCC regulations regarding radio-emitting devices.

Installing or Replacing the Batteries

GyroRemote operates on four standard or alkaline

AAAbatteries. When GyroRemote’s batteries reach

20% of a full charge the Status LED will blink when it normally lights solid. For instance, clicking and holding a button on a fully charged remote causes the Status LED to light solid. Clicking and holding a button on a remote with low batteries will cause the Status LED to blink intermittently. To replace the batteries:

1.From the bottom of the remote, slide the battery cover open by pushing firmly downward with your thumbs.

2.Remove the battery holder.

3.Insert four new AAA batteries into battery cradle and return cradle into GyroRemote. When replacing the cradle into the remote, align the positive (+) labels. See Illustration for proper cradle alignment.

5

Page 7
Image 7
Gyration GyroRemote and Mobile RF Keyboard user manual Powering Off GyroRemote, Installing or Replacing the Batteries