To Change the Channel the Keyboard is Using
When two devices are being used in the same proximity, each device should be set to operate on a unique channel. To change the channel:
1.Click and hold the CHANNEL button on the RF Keyboard for 2 seconds. When you release the button, the keyboard will change to the next channel and the green LED will flash. The number of times the green LED flashes indicates the new channel the keyboard is using.
If a Teach/Learn sequence has already been performed, it will not be necessary to
Tip: If you are installing three or more devices on a single receiver, see “Installing 3 or More Devices” on page 13.
Powering Off the Keyboard
It is not necessary to power down the keyboard when it is idle unless the unit will be traveling and may encounter inadvertent key presses.
1.To power down the keyboard, simultaneously press and release the CHANNEL button and TEACH button on the top of the keyboard. The keyboard will immediately enter deep sleep mode and will be unresponsive to key or button clicks. The unit will confirm it is powering off by flashing its LED three times.
2.Repeat this sequence to power on the unit. The unit will confirm it is powering on by flashing its LED for 1 second.
Note: If the keyboard’s protective cover is used, power down is not required. The cover will prevent inadvertent key presses and the unit will remain in sleep mode with no radio transmission.
9
