Haier BD-478A service manual How to handle the seal bar for poor sealing

Models: BD-478A

1 61
Download 61 pages 29.49 Kb
Page 23
Image 23
near thermal source or not; if the room temperature is too high or not; if the condenser is blocked by cloth pieces or paper or dirt or not. Any one of these matters will affect heat radiation of condenser and refrigeration ability will be reduced.

near thermal source or not; if the room temperature is too high or not; if the condenser is blocked by cloth pieces or paper or dirt or not. Any one of these matters will affect heat radiation of condenser and refrigeration ability will be reduced.

(3)Check if there are too much food stored in the freezer, if hot food has been put in or not, Too full of food is not good for cold air circulation. Hot foodstuff can only be put in when it gets cool.

(4)Check if the freezer door has been closed well, if the door seal bar is too dirty and the door cannot be sealed well. Remove dirt and put on a little talcum powder.

(5)Frequent opening and extended opening of freezer door will reduce refrigeration ability.

12.1.8 How to handle the seal bar for poor sealing

If there is too much dirt and the sealing effect is not well, please take a rag and dip in warm water and clean the seal bar. After cleaned, put on a little talcum powder. If there is still seam, you can put an electrical blower outside the seal bar and make it warm,

MAINTENANCE SERVICE AND TROUBLE SHOOTING

Maintenance Service and Trouble Shooting

keep the temperature at 50-60, press the bar to make it recover, and press the bar around by hand, so that it can recover. If this is

22

PDF created with pdfFactory trial version www.pdffactory.com

Page 23
Image 23
Haier BD-478A service manual How to handle the seal bar for poor sealing, Maintenance Service And Trouble Shooting