Hand Held Products 2020/5620 Troubleshooting Base, Replacing the IT2020 Interface Cable

Replacing the IT2020 Interface Cable:

1.Turn the power to the host system OFF.

2.Disconnect the base’s cable from the terminal or computer.

3.Turn the base upside down.

4.Pull the connector out while maintaining pressure on the connector release clip.

5.Replace with the new cable.

Insert the connector into the opening and press firmly. The connector is keyed to go in only one way, and will click into place.

Changing the IT5620

Battery:

1.Remove the screw on the end cap.

2.Remove the battery from the handle.

3.Insert battery.

4.Replace end cap and screw.

Troubleshooting Base

End Cap

If your base is not functioning properly, review the following

troubleshooting guidelines to try to isolate the problem.

Is the red LED on?

If the red LED isn’t illuminated, check that:

•The power cable is connected properly and there is power at the power source.

•The host system power is on (if external power isn’t used).

Is the green LED on?

If the green LED isn’t illuminated, check that:

• The scanner is correctly placed in the base.

12 - 2 IMAGETEAM™ 2020/5620 System Manual