Wand Emulation Idle

The idle describes the state of the scanner when no data is being transmitted. When in Wand Emulation mode, you must set the scanner’s idle state to match the idle state for the device to which the scanner is connected. Default = Idle High.

* Idle High

Idle Low

Wand Emulation Data Block Size

This transmits the data in smaller blocks to prevent buffer overflow. Default = 40.

20

* 40

60

80

Wand Emulation Delay Between Blocks

This sets the delay time between data blocks. Default = 50ms.

5ms

* 50ms

150ms

500ms

IMAGETEAM™ 2020/5620 System Manual

2 - 15

Page 53
Image 53
Hand Held Products 2020/5620 Wand Emulation Idle, Wand Emulation Data Block Size, Wand Emulation Delay Between Blocks