Chuck Guard
(201)
Properly in place
Safety
Mechanism
Pin (251) properly extended
into the recess, allowing
the lathe to operate.
Rotating
Plate
(252)
Safety
Figure 25 Mechanism
5.The Chuck Guard (201) has a safety
interlock and the Lathe will not operate unless the guard is properly in place. Install the guard if not already done so. Check to ensure that the Guard
(201)is in its operating position over the Chuck (2). The Pin (251) must be correctly seated in the recess in the Rotating Plate (252) for the Lathe to work.
6.Plug in the Lathe.
Power Switch (178)
Figure 26 Speed Control Knob (180)
7.Move the Power Switch (178) to the “On” position (switch will turn Red) and place the
8.Move the Variable Speed Control Knob (180) to the needed operating speed to
start the Lathe.
REV 10b
To Stop the Lathe
1.Turn the Speed Control Knob (180) to 0.
2.Move the
3.Turn the Power Switch (178) OFF.
4.Unplug the Lathe when not in use.
SKU 93212 | For technical questions, please call | Page 21 |
