Basic Operations
WARNING: Make sure the Lathe power is off and the Lathe is unplugged before setting up a project or working near the Chuck (2).
Following are some of the basic operations used with the Lathe. It is recommended that you become familiar with mini lathe techniques before using this tool. Consult books on the subject and/or web page resources for your project before using this tool.
Holding a project between the Chuck (2) and the Live Center (143)
(As seen from back of Lathe to show detail)
Figure 27
1.Use the chuck to hold the workpiece firmly. Then, use the Live Center (143) to fix the other end.
Note: If you change the Live Center to a drilling chuck (sold separately), you start your drilling immediately.
Face Cutting
Figure 28
2.Use the chuck to hold the workpiece firmly, and the cutter positioned as shown above for face cutting. The edge of the cutter must be at the same height as the center.
Internal Cutting
Figure 29
3.By changing the tool post angle and adjusting the compound rest, you can make internal cuts.
|
| REV 09c, 10b |
Page 22 | For technical questions, please call | SKU 93212 |
