Harman-Kardon AVR 520 owner manual Reassigning Device Control Selectors, 41PROGRAMMING THE REMOTE

Programming the Remote

Reassigning Device Control Selectors

Although each Input Selector e is normally assigned to the category of product shown on the remote, it is possible to reassign one of these buttons to operate a second device of another type. For example, if you have two VCRs but no satellite receiver, you may program the “SAT” button to operate a second VCR. Before following the normal programming steps for either Three-Digit entry or Auto Search code entry, you must first reassign the button with the following steps:

1.Press the Input Selector e you wish to reassign and the Mute Button 43 at the same time until the red light appears under the Input Selector e and the Program/ SPL Indicator c flashes amber.

2.Press the Input Selector e for the device you wish to program into the reassigned button.

3.Enter the three-digit code for the specific model you wish the reassigned button to operate.

4.Press the same Input Selector e pressed in Step 1 once again to store the selection. The red LED under the re-assigned Input Selector will flash three times and then go out.

Example: To use the CBL/SAT button to operate a second VCR, first press the CBL/SAT Input Selector e and the Mute Button 43 at the same time until the red light glows under the CBL/SAT e button. Press the VCR e Button, followed by the three-digit code for the specific model you wish to control. Finally, press the CBL/SAT Button e again.

Resetting the Remote Memory

As you add components to your home-theater system, occasionally you may wish to totally reprogram the remote control without the confu- sion of any commands, macros or ”Punch- Through“ programming that you may have done. To do this, it is possible to reset the remote to the original factory defaults and com- mand codes by following these steps. Note, however, that once the remote is reset, all com- mands or codes that you have entered will be erased and will need to be re-entered:

1.Press any of the Input Selector Buttons e and the ”O“ Button r at the same time until the Program/SPL Indicator c begins to flash amber.

2.Press the ”3“ Button r three times.

3.The red LED under the Input Selector e will go out and the Program/SPL Indicator c will stop flashing and turn green.

4.The Program/SPL Indicator c will remain green until the remote is reset. Note that this may take a while, depending on how many commands are in the memory and need to be erased.

5.When the Program/SPL Indicator c goes out, the remote has been reset to the factory settings.

41PROGRAMMING THE REMOTE