WinTV-USB
To connect the audio from your VCR or camcorder, use an 1/8” stereo minijack exten- sion cable (1/8” male minijacks on one end, and RCA onthe other end) and connect the “Audio Output” RCA” on the VCR or camcorder to the Audio Line In jack on the WinTV USB.
ote:. If you need a female RCA to 1/8” minijack adapter, these Nadapters can be found at most Radio Shack stores.
Connecting the WinTV-USB to a Sound Card
The board's audio output should be connected to a sound card using the supplied Audio Cable:
-plug one end of the Audio Cable into the jack marked LineOut (Audio Line Out jack J4) on the USB unit
-plug the other end of the Audio Cable into your soundcard’s LineIn jack.
ote: Most sound cards have three round jacks on the outside of Nthe PC. They are: Microphone Input, Audio Output and Line
Input. The Audio Output would go to your speakers, while the Microphone input might go to a microphone (if you are using one). The LineIn jack is normally indicated on the sound card by the words IN or LineIn stamped into the metal bracket on the outside of your PC. This is where you would plug your Audio Cable, Also Some Laptops do not have a Line in and you would have to connect the USB device to the Mic input on the Laptop, or to a seperate set of powered speakers.
Adjusting the Audio Volume
Once the audio cable is connected to your Sound Card, the WinTV application can change the audio volume coming from the WinTV USB by adjusting the LineInput sound volume of the VolumeControl program in Windows.
The VolumeControl program is normally installed with Windows or by the sound card installation program, and allows the control of volume from the various sound sources. If you cannot hear sound when running the application, you might need to check the volume level of LineInput in VolumeControl.
