7

Installing the Anti-Scalp Wheels

Parts needed for this procedure:

2Anti-scalp wheels

2Wheel bolt

2Locknut

9

Lubricating the Tractor

No Parts Required

Procedure

Ensure that all of the necessary points on the tractor are lubricated; refer to Greasing and Lubricating the Tractor in Maintenance.

Procedure

Mount the anti-scalp wheels onto the wheel brackets with the wheel bolts and locknut (Figure 9).

 

 

Figure 9

 

1.

Wheel

3.

Locknut

2.

Wheel bracket

4.

Wheel bolt

Note: Use the same hole height on both sides.

8

Preparing the Cutter Deck Discharge Chute

No Parts Required

Procedure

1.Remove the roll pin from the discharge chute spring and discard the pin.

Note: The roll pin is for shipment only

2.Ensure that the spring returns the discharge chute to the full down position.

10

Checking the Safety Interlock System

No Parts Required

Procedure

Check the safety interlock system; refer to Testing the Safety Interlock System in Operation.

11

Purging the Hydro Transaxle

No Parts Required

Procedure

Shipping and handling can introduce air into the hydro transaxle. For proper performance, remove all the trapped air.

1.Move the tractor to a flat, level surface

2.Place the drive control in the Push position (Figure 10).

14

Page 14
Image 14
Hayter Mowers RT380H Installing the Anti-Scalp Wheels, Lubricating the Tractor, Preparing the Cutter Deck Discharge Chute