1
Installing the Front Wheels
Parts needed for this procedure:
2 Front wheels
2Shim washers (as required)
2Flat washers
2Cotter pins
2Hub caps
2
Checking the Tyre Pressure
No Parts Required
Procedure
Ensure that the air pressure in the front and rear tyres are 20 psi (138 kPa). Check the pressure at the valve stem (Figure 4).
Procedure
1.Install the shim washers onto the axle.
2.Install the wheel onto the axle with the valve stem facing out.
3.Slide the flat washer onto the axle (Figure 3).
Figure 4
1. Valve stem
|
| Figure 3 |
1. | Flat washer | 3. Hub cap |
2. | Cotter pin |
|
3
Installing the Steering Wheel
Parts needed for this procedure:
1Steering wheel
1Spirol pin
4.Insert the cotter pin through the axle and bend the ends of the pin apart (Figure 3).
Note: If the cotter pin does not fit, remove the shim washer(s) as needed.
5.Push the hub cap (Figure 3) onto the end of the axle.
6.Repeat steps 1 through 5 on the opposite side of the tractor.
7.Grease the wheel bearings until the grease comes out of the bearing seal area.
Procedure
1.Move the front wheels so that they face straight ahead.
2.Slide the steering wheel over the steering shaft and line up the hole in the steering wheel with the hole in the shaft (Figure 5).
Note: From the seat you should be able to read the brand logo on the steering wheel.
11
