Healthrider HRTL99510.0 manual Make sure that the power cord is unplugged

1.	Make sure that the power cord is unplugged.	1
	Place a piece of cardboard below the rear of the
	Frame (57) to protect the floor or carpet.
	Attach the Left Wheel Cap (92) to the Base (91)
	with two #8 x 3/4" Screws (2).
	Attach the Right Wheel Cap (not shown) to
	the right side of the Base (91) in the same
	way.		91	2
							57
					92 Cardboard
2. Pull the Upright Wire (77) and the Ground Wire		2
	(90) through the indicated hole in the Base (91).
	Attach the Ground Wire (90) to the Base (91)				75
	with a #8 x 1/2" Ground Screw (10).			Hole
	Press the Grommet (75) into the square hole in		77
	the Base (91).
				10	90	91
3. Identify the Left Upright (88), which is marked		3
	with a “Left” sticker. Have a second person hold			77
	the Left Upright near the Base (91).					88	Wire
	See the inset drawing. Tie the wire tie in the
	Left Upright (88) securely around the Upright						Tie
	Wire (77) about 8 in. (20 cm) down from the							77
	end. Then, pull the other end of the wire tie until
	the Upright Wire is routed completely through			Wire
	the Left Upright. Note: The Upright Wire should
	bend so that the connectors are pointing down-			Tie
	ward.
			88
		7			77	91