Hearth and Home Technologies 31ST-ACC Pedestal and Ash Removal System Cont’d, Adapters

3100 Wood Stove Series (ACC)

R

Pedestal and Ash Removal System (Cont’d)
Installing Pedestal Assembly
1.	Remove screws on adapter and slide pedestal over
	adapter on bottom of stove. Figure 22.1.
2.	Line up holes in sides of pedestal with holes in adapter.
3.	Securely tighten pedestal into place.		Grate
4.	Carefully stand stove up and place in desired location.		ARS
5.	Slip wooden decorative strips onto pedestal edges.
			Channel
Finishing the ARS Installation
1.	Re-install the ARS channel that was removed in Step 3 on
	page one and secure with 2 bolts previously removed.
	Set the grate into the ARS channel	Replace the 2	Replace both bricks
	front cut bricks. Figure 22.2.
			back into firebox
2.	Install the ash drawer.
3.	Check to make sure baffle boards and ceramic blanket are
	in their proper locations. (see page 29).		Figure 22.2

NOTE: If installing a floor installation of an outside air kit on a Step Top model with a pedestal assembly you must attach the enclosed cover plate to the back of the stove. Other wise you may discard this piece. Figure 22.3.

Adapters

Cover

Plate

Ash Removel

Drawer

Figure 22.3

Oak

Pedestal

Trim

Figure 22.1

Page 22 7033-277F September 1, 2008