3100 Wood Stove Series (ACC)
R
C.Door Handle Assembly
1.Install washer on door handle shaft.
2.Slide door handle through door.
3.Install second washer(s) as shown.
4.Install key in groove.
5.Align groove in latch cam with key; slide latch cam over shaft
6.Install locknut but do not overtighten as the door handle needs to move smoothly.
7.Install spring handle turning in a
CAUTION
•Do NOT overtighten lock nut.
•Door handle needs to move smoothly.
D. Adjusting The Blower Speed Control
The blower speed control for this unit is adjusted at the factory, and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.
1.With the appliance plugged in, turn the speed control knob to slow (full clockwise).
2.With a small screwdriver, adjust the blower speed by turning the adjustment mechanism through the hole on the side of the speed control.
3.Adjust the speed so the blower runs slowly, but does not stop. Turn clockwise to slow the blower and counterclockwise to increase the speed.
| Door Cross Section |
Latch Cam | (example) |
Locknut |
|
| Spring |
| Handle |
| Door Handle |
| Spacing |
| Washers |
| Square Key |
Figure 24.1 |
|
Page 24 |
| September 1, 2008 |
