Hearth and Home Technologies 31M-ACC-MBK, 31ST-ACC owner manual Installing Leg Kit, Corners. Figure

R

3100 Wood Stove Series (ACC)

B. Leg Kit and Ash Removal Installation (ARS) for Step Top Uni-Body

NOTE: The Ash Removal System, must be installed first before installing the legs.

Installing Leg Kit

1.	Remove leg mounting brackets packaged inside firebox.
2.	Attach the 2 bottom screws of the mounting brackets to
	the bottom of the stove with 1/4”-20 Phillips head screws.
	These screws are located in the component pack .
	Leave the bottom 2 screws loose so you can slide the ash
	pan assembly bottom slots over the screw heads. This al-
	lows the weight of the ash pan to rest on the screws while
	you are attaching the top 2 screws. Once the ash pan is
	attached, tighten all screws. Figure 23.2.
3.	Loosely assemble bolts into the corner of the mounting

Lay stove flat on its back on protective padding or pallet

Leg Brackets

Ash Drawer

Insert 2 bottom screws loosely

	brackets for leg attachment. Figure 23.1.
4.	Slide legs onto mounting brackets and tighten. Make sure
	the legs are up against the bracket. There are leveling
	bolts in 2 legs. These leveling legs should be in opposite
	corners. Figure 23.1.
5.	Carefully stand stove up and place in desired location.
	Do NOT tilt up on the cast iron legs, it could damage the
	legs.
6.	Use leveling bolts on legs to stabilize and level stove.

Finishing the ARS Installation

1.Follow steps 1 through 3 on page 22. See also Figure 22.2.

Leg Mounting Brackets are

packaged inside firebox.

Leveling Legs at

opposite corners

Figure 23.1

Figure 23.2

CAUTION

Do NOT tilt the unit on the cast iron legs.

•Tilting could lead to property damage.

•Lift the unit upright and place it into position on the floor protector.

September 1, 2008 7033-277F Page 23