3100 Wood Stove Series (ACC)
R
F. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1.Remove the right side shield by removing 2 screws in the back using a Phillips head screw driver.
2.Remove 4 screws from channel access cover and remove cover.
3.Locate 2 channel nuts inside of chamber and remove using a 7/16 socket wrench. Slide out tube channel assembly.
NOTE: Service Space
In order to replace the tube channel assembly a clearance of 19 inches (483mm) is required on the right side of stove in order to remove the tubes with the stove in place.
If space is not available, the stove will have to be discon- nected from the chimney to proceed with the tube replace- ment.
NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove them.
Replacing Tube Channel Assembly
1.Slide one gasket onto each tube.
2.Slide the tube channel assembly into side of firebox and insert each tube into the corresponding hole in the tube channel rack starting with the back hole first.
3.Make sure tube channel assembly is flush against the side of the stove and secure with channel nuts.
4.
| Slide one gasket |
| |
| over each tube |
| |
Tube Channel Rack | Channel | Channel Cover | |
Access | |||
| Screws (4) | ||
| Cover | ||
|
|
Remove 
2 Screws
Channel
Nuts (2)
Tube Channel
Assembly
Figure 36.1
Side Panel
Page 36 | September 1, 2008 |
