R
CB 1200 Pellet Stove
I. Door Installation
To install door:
1.Carefully remove door from packaging.
2.Line up hinges with hinge pins on appliance body, and slide door down until it sits securely on pins. Figure 21.1.
3.If door is plated, be sure to clean all plated surfaces and glass with a glass cleaner to ensure all oils are removed before your first burn.
4.Remove all labels from glass before burning appliance.
To adjust latches: | |
1. | Close door securely. |
2. | Place rod in slot on the bracket on the door and close |
| latch. |
3. | Latch must close tightly enough to ensure an airtight |
| seal between the door and the body of the appliance. To |
| increase tension on the latch, turn the rod clockwise a few |
| turns, then attempt to close the latch, until it is snug. Do not |
| overtighten; you should be able to close the latch with your |
| hand. Figure 21.2. |
4. | After adjusting the latch, place a Phillips head screw driver |
| in the end of the rod, and tighten the nut with a wrench. |
| This will maintain the correct tension on the rod and latch. |
Hinge Pin 
Hinge
Figure 21.1
Rod and nut
Rod and nut
Figure 21.2
J. Thermostat Installation
1. A 12 volt AC thermostat is required to operate this pellet appliance. You may use the included wall mount thermo- stat or purchase an optional programmable thermostat or remote control. It is equipped with an adjustable heat anticipator. The current rating is .05 amps. The anticipator needs to be adjusted to the lowest setting available.
2.When mounting a thermostat on a wall, be sure to follow your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accurate readings. The thermostat should be mounted on an inside wall and not in direct line with the appliance convection air.
NOTE: If the thermostat is located too close to the appliance, you may need to set the temperature setting slightly higher to maintain the desired temperature in your home.
3.There is a 4 screw terminal block located on the back lower left corner of the stove directly above the power cord inlet. The center 2 screws are for the thermostat wires.
Power Outlet |
Terminal Block. |
Center 2 screws for |
Thermostat Wires |
Figure 21.3
CAUTION
Shock hazard.
•Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appliance.
September 1, 2008 | Page 21 |
