Hearth and Home Technologies CB1200-B owner manual

R

CB 1200 Pellet Stove

Symptoms	Possible Cause	Corrective Action
Convection blower fails to	#1 snap disc defective.	Replace snap disc.
start.	Blower not plugged in.	Check that blower is plugged into wire har-
		ness.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Exhaust blower fails to	Blower not plugged in.	Check that blower is plugged into wire har-
start or does not shut off.		ness.
	Blower is clogged with ash.	Clean exhaust system.
	Blower is defective.	Replace blower.
	Control box is defective.	Replace control box.
Large, lazy flame, orange	Dirty appliance.	Clean unit, including firepot, heat exchang-
color. Black ash on glass.	Poor fuel quality, high ash content.	ers and venting system. Remove stainless
		steel baffle from firebox to clean ash from
		on top of baffle. Clean behind rear brick
		panels. Change fuel brand to premium.
	Firepot clean-out plate not completely	Check that firepot clean-out plate is fully
	closed.	closed.
		Reduce feed rate using feed rate adjustment
	Excessive amount of fuel.	control rod located inside hopper.
Nuisance shutdowns.	Low flame.	Increase feed by opening feed rate adjust-
		ment control rod located inside hopper.
	Sawdust buildup in hopper.	Clean hopper, see page 30.
	Feed motor is reversing.	Check for good connections between feed
		motor and wire harness.
	Defective thermocouple.	Replace thermocouple.
	Defective control box.	Replace control box.
	Firepot more than 1/2 full.	See page 31 for detailed instructions for
		“High Ash Fuel Content Management”
Appliance calls for heat.	Thermocouple is defective or not properly	Check connections on thermocouple or
Call light illuminates.	plugged in.	replace if defective.
Exhaust blower starts.		A flashing yellow light on the control box
No feed or igniter.		indicates a problem with the thermocouple.
	Defective control box	Replace control box.

September 1, 2008 7014-082D Page 27