CB 1200 Pellet Stove |
| R | |
|
| ||
H. Glass Replacement |
|
| |
| WARNING |
| Door Latch |
| • Glass is 5mm thick high temperature heat- | Top & Bottom Frame |
|
| resistant ceramic glass. |
| |
|
|
| |
| • DO NOT REPLACE with any other material. |
|
|
| • Alternate material may shatter and cause |
|
|
| injury. | Center Posts |
|
|
|
| |
| • Remove door from appliance and place face down |
| Side |
| on a protected surface to avoid scratching the door. | Glass | |
| Frame | ||
| • Remove all door rope. | ||
|
|
| |
1. | Replacing Center Glass |
|
|
NOTE: DO NOT LET Air Wash Spacers fall down from |
|
| |
| top frame when removing and replacing center |
|
|
| glass. |
|
|
a.Be sure the appliance is allowed to cool, has been Figure 34.1 unplugged and the exhaust blower is off.
b. Using a nut driver remove the (5) bottom nuts and remove the bottom glass frame. Figure 34.2.
c.Slightly bend up and out of the way the 2 center posts and slide the glass out the bottom.
d.Slide new glass in, reposition the 2 center posts and
e.
2.Replacing Side Glass
NOTE: When removing the side glass with the door latch, you must remove the door latch first before removing the side frame. Use a pow- ered Phillips head screw driver to remove the
4screws.
a.Be sure the appliance is allowed to cool, has been unplugged and the exhaust blower is off.
b.Remove side glass frame.
c.Loosen the top and bottom frame and slightly bend up and out of the way.
d.Slide glass out the side and slide new glass in.
e.
f.
Remove Door Latch First |
and then Side Frame |
Door Frame |
shown with no |
Glass or Glass |
Frames |
Remove 5 nuts from Bottom Frame |
Figure 34.2
WARNING
Handle glass with care.
• Inspect the gasket to ensure it is undamaged.
• Do NOT strike, slam or scratch glass.
•Do NOT operate appliance with glass assembly removed.
•Do NOT operate with glass cracked, broken or scratched.
Page 34 | September 1, 2008 |
