Hearth and Home Technologies II-B owner manual Optional Accessories, Fan location

C. Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the factory installed junction box before the appliance is permanently installed (see Figure 7.1).

Fan Installation

To provide best airflow, we recommend positioning fan on the left side (as viewed from appliance interior side - see Figure 7.2). NOTE: It is recommended fan be in- stalled prior to gas line installation.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the appliance ON/ OFF switch pigtails.

APPLIANCE
INTERIOR
SIDE
FAN
	DRIP
	TRAY
Figure 7.2	Fan location

FAN SPEED
CONTROL		WIRE LEAD
(RHEOSTAT)	6 FT.
		1 MALE END
	APPROX.	1 FEMALE END

TEMPERATURE

SENSOR SWITCH

WIRE LEAD

2 FEMALE ENDS

6 FT.

APPROX.

FAN KIT

#GFK-160T

PLUG AND WIRE

ASSEMBLY

DETAIL A

JUNCTION BOX

SEE DETAIL A

NOTE: If any of the original wire as supplied with the appliance must be replaced, it must be replaced with the type 105oC rated wire.

Figure 7.1 Fan Wiring Diagram

18 Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07