Hearth and Home Technologies II-B Appliance Setup, Remove Shipping Materials, Clean the Appliance

9 Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the firebox.

Placing Lava Rock

Place lava rock on refractory support pan. Cover entire support pan surface (see Figure 9.1).

B. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

C. Accessories

Install approved accessories per instructions included with accessories. See Service Parts List for appropriate acces- sories. Refer to Section 13.

WARNING

Shock or fire risk.

Use ONLY optional accessories approved for this appliance.

•Using non-listed accessories voids warranty.

•Using non-listed accessories may result in a safety hazard.

•Only Hearth & Home Technologies approved

accessories may be used safely.

D. Lava Rock and Ember Placement

WARNING

Explosion Risk.

•Follow ember placement instructions in manual.

•Do NOT place embers directly over burner ports.

•Replace ember material annually.

Improperly placed embers interferes with proper burner operation.

Figure 9.1 Placement of Lava Rock

Placing the Ember Material

Ember material is shipped with this gas appliance. To place the ember material:

•Embers CANNOT be placed directly over ports.

•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the dime-size ember pieces just in front of the port trail, but not on or in between the ports (see Figure 9.2). Fail- ure to follow this procedure will likely cause lighting and sooting problems.

Figure 9.2 Placement of Ember Materials

•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.

24 Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. G • 8/07