Page 36 Heat & Glo • NorthStar EPA Fireplace • 480-1081C September 1, 2008 September 1, 2008
September 1, 2008
9.
There is very little room to pull the timer assembly out the
frontofthereplace.
P
lace your hand through the access
doorintheoor ofthereplace. Letthetimerassembly
drop down and then rotate it up through the access door.
Figures 36.3 and 36.4.
7. Moveslidercontrolrodandlinkagearmtotherightand
out of the way. Pull rod down and out towards you. Lay
the control arm down. Figures 36.1 and 36.2.
8. Thetimerassemblyisboltedundertheface.Usea7/16
socket wrench to remove the 2 bolts. Figure 36.3.
Linkage Arm
Slider Control Rod
Linkage Arm
Slider Control Rod
Remove 2 bolts from timer assembly
Timer Assembly
with Gasket
1. Loosen set screw on timer, remove 2 screws and remove
timer. See Figure 36.5.
2. Install new timer using same 2 screws. It is very impor-
tant that the D cut side of the timer shaft is facing the
opposite side of the linkage timer arm. Figure 36.6.
D cut side of timer shaft must face
away from the Linkage Timer Arm
Remove Timer
Loosen Set Screw
Remove
2 screws
Figure 36.1
Figure 36.2
Figure 36.3
Figure 36.4
Figure 36.5 Figure 36.6