Hearth and Home Technologies NorthStar-GT, NorthStar-NT, NorthStar-BK Firebrick Replacement

C. Firebrick Replacement

The firebox of your fireplace is lined with high quality firebrick, which has exceptional insulating properties. There is no need to use a grate; simply build a fire on the firebox floor. Do not operate the fireplace without firebrick.

IMPORTANT: The bricks are very similar in size. Be certain you have the proper brick in the correct location. Measure the brick size for accuracy.

After the coals are completely cooled, remove all old brick and ash from unit and vacuum out firebox.

1.Remove new brick set from box and lay out to diagram as shown in Figure 58.1.

2.Lay bottom bricks in unit.

3.Install rear bricks on the top of the bottom bricks.

Slide top of bricks under clip on back of firebox wall and push bottom of brick back.

4.Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.

	2	1	1	1	2
	3				3
3					3
			3		3
3		4			3
					4
		1		1
Figure 60.1	Brick Pattern

Use Part SRV7000-306 when ordering individual brick. Provide brick dimension or copy this page, mark the desired brick and take it to your authorized dealer.

	2	1	1	1	2
	3	3		3	3
	3	4		4	3
	3	1		1	3
Figure 60.2	Brick Pattern

#	Brick Size	Qty. In Set
1	13-1/4” x 4-1/2” x 1-1/4”	5
2	13-1/2” x 4-1/2” x 1-1/4” w/ 1-1/2” chamfer	2
3	12” x 4-1/2” x 1-1/4”	8
4	12-1/2” x 4-1/2” x 1-1/4”	2

Page 60 Heat & Glo • NorthStar EPA Fireplace • 480-1081C September 1, 2008