9 Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during installa- tion. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting, it CANNOT be changed at a later time.
Note: Actual unit may look different than the fireplace shown in this section.
2 SCREWS
Figure 9.4 Remove the seal cap.
Figure 9.1 For top vent, remove the two screws holding the top heat shield in place. For rear vent, see Section 9.B.
WARNING! Risk of Fire! Do not remove heat shield. El- evated header temperatures may cause a fire.
Figure 9.2 Rotate the top heat shield to the vertical position as shown above. The heat shield must remain in the vertical position.
Figure 9.5 Remove the insulation basket and white insula- tion from the center vent pipe.
2 SCREWS
Figure 9.3 Replace the two screws as shown. | Figure 9.6 Remove the insulation from the outer vent pipe. |
39 |
