Hearth and Home Technologies RUTHERFORD-50 owner manual F. Tools and Supplies Needed

F. Tools and Supplies Needed

Before beginning the installation be sure the following tools and building supplies are available:

Reciprocating saw	Framing material
Pliers	Non-combustible sealant
Hammer	Gloves
Phillips screwdriver	Framing square
Flat blade screwdriver	Electric drill and bits
Plumb line	Safety glasses
Level	Tape measure

1/2-3/4 in. length, #6 or #8 self-drilling screws Misc. screws and nails

G. Typical Fireplace Components

•Hearth Molded Brick Panel

-Molded brick panel kit must be installed, but is sold separately

•Grate Assembly

•Outside Air Kits

-Duct must be installed, but sold separately

H. Inspect Fireplace and Components

WARNING! Risk of Fire and/or Explosion! Damaged parts could impair safe operation. DO NOT install dam- aged, incomplete or substitute components. Keep fireplace dry.

•Remove fireplace from pallet.

•Remove fireplace and components from packaging and inspect for damage.

•Remove the hearth molded brick panel, screens and grate from inside the unit.

•Vent system components, doors, molded brick panels and mortar are shipped in separate packages.

•Report to your dealer any parts damaged in shipment.

•Read all the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.

Heat & Glo • RUTHERFORD-50 • 4059-333 Rev F • 11/08 17